Figure 1-1.
MAOM-37447 Evaluation Module (with micro-controller)
Mini USB
to PC
High-speed Inputs
Mini-SMP (GPPO)
High-speed Outputs
2.92mm
MONCLK Output
REFCLK Input
+3.
3V
+1.
8V
MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support
5
MAOM-37447 Quad 24G/26G CDR with Integrated EML Driver Evaluation Module User Guide
Rev -
User Guide
DC-0014098
1.4
Hardware Setup
The EVM is configured for use out of the box. Please refer to
for locations of various connectors.
The following steps outline the initial setup of the EVM.
1. Verify these jumpers are in place: JP2, JP6, JP7, JP8 and JP16
2. Connect P8 header with +1.8V supply and P12 with +3.3V (observe polarity marking).
3. Connect high speed input signal to mini-SMP (GPPO) connectors and output to 2.92mm connectors.
4. Connect provided USB cable from J17 to host PC for software control through graphical user interface (GUI).
Once the necessary hardware connections for the EVM are in place, the next step is to launch the control software
for the EVM.
