Hydra 800+ Chapter 3 - System Set Up
If the total ca
city
ition B
nd it will
automatically split
the volumes (A+B /
C
pa
exceeds 2TB, make
sure the 2TB switch
is set to pos
a
+D).
For the FAST mode,
hard drives of
identical capa ities
l
mallest capacity.
The drives show up as one large single volume. Spanning is an
cross the drives.
c
are recommended.
If different, the tota
amount of the
space that can be
used will depend on
the drive with the
s
BIG (JBOD spanning)
array (not RAID) that is written sequentially a
By itself, it does not provide any performance or redundancy
benefits. Use this if you have installed 1-4 hard drives with
different capacities.
FAST (RAID 0 sstriping)
The drives show up as one large single volume. This mode
quires 4 identical drives to implement. Used where speed is
e primary objective, RAID Level 0 (also called striping) is not
redundant. This form of array splits each piece of data across
ents; since data is written without any form of
ll
re
th
the drives in segm
parity data-checking, it allows for the fastest data transfer of a
other modes. However, if one drive becomes damaged, the
whole array can become corrupted.
Page 10
