USER MANUAL
PD-SATA USB/LAN
Page 17 / Chapter 4 - LAN Disk Setup
USER MANUAL
PD-SATA USB/LAN
Make sure all
current operations
are done before
rebooting the
device.
Resetting the
device will remove
all folders from the
sharing list, erase
the FTP accounts
and reset all other
settings!
•
System Reboot:
This can be used to restart the network
drive after a firmware upgrade.
1. Click on Reboot.
2. Confirm the pop-up message to restart the device.
3. Wait for about one minute before refreshing the page.
•
Factory Defaults:
If you experience problems and after a
firmware upgrade, it is recommended to reset all settings.
1. Click on Reset.
2. Confirm the pop-up message to reset all settings.
3. Click on Reboot to restart the device.
Page 17 / Chapter 4 - LAN Disk Setup