Q: My HDD is not recognised.
A:
Please make sure to set the jumper of your hard drive to
Master when you install the drive and then use the disk utility of
the web admin interface to format the drive.
For troubleshooting
and to upgrade the
firmware, connect
the LAN disk
directly to your
computer using the
standard Ethernet
cable.
Q: I get Error Code -36
A:
The Finder cannot complete the operation because some
data in "smb://storage" could not be read or written.
If you get the above error message, use the IP address instead
of STORAGE. See following steps:
1) Log in via your web browser.
2) Under SMB Server, make sure the folder you want to access
is in the Shared List - for example, the PUBLIC folder without a
password.
3) Go to IP Config, make sure it is set to Automatic IP and write
down the IP address you see there.
4) Go to your Finder and select Go/Connect to Server
5) Type smb://IP/PUBLIC and hit Connect. For the IP use the
IP address you wrote down in step 3, for PUBLIC use the
name of the folder you added to the Sharing List in step 2.
6) If the LAN disk is connected directly to your computer using
the Ethernet cable, the default IP address is 169.254.0.1.
LAN disk settings
do not apply when
the disk is mounted
via USB connection.
If you can not find
your city on the time
zone list, please set
the time manually
by changing the
numbers for “Time”,
then saving the new
setting.
About this Manual
The firmware this manual is based on might be different from
your device. Images and descriptions might therefore slightly
vary between this manual and the actual product you have.
© Copyright 2006 by Macpower & Tytech Technology Co., Ltd. all Rights Reserved
The information contained in this manual is believed to be accurate and reliable. Macpower & Tytech
Technology assumes no responsibility for any errors contained in this manual. Macpower & Tytech
Technology reserves the right to make changes in the specifications and/or design of this product without
prior notice. The diagrams contained in this manual may also not fully represent the product that you are
using and are there for illustration purposes only. Macpower & Tytech Technology assumes no responsibility
for any differences between the product mentioned in this manual and the product you may have.
- 16 -
