R2-3500 Media Player/Recorder Setup Menu
4 Setup Menu
To enter the menu, select Setup from the main screen (press the Guide button to return to the
main screen if you are somewhere else) or press the Setup button on the remote control.
Use the arrow keys on your remote control to navigate the setup menu, use the Enter key to open
and confirm settings, and use the Return key to cancel out of a menu.
4.1 Audio
4.1.1 Night Mode
Night mode can be used to reduce the maximum
volume, preventing excessive sound in the evening.
Off: Unrestricted output (maximum volume).
On: Maximum output set to low volume.
Comfort: Maximum output set to medium volume.
4.1.2 Digital Output
RAW is the preferred output when the
receiver/amplifier is capable of decoding the signal.
If there is no sound on your system, switch to LPCM.
.
HDMI LPCM: LPCM audio output via high definition multimedia interface cable.
HDMI RAW: RAW audio signal via high definition multimedia interface cable.
SPDIF LPCM: LPCM audio output via optical audio cable.
SPDIF RAW: RAW audio signal via optical audio cable.
4.2 Video
4.2.1 Brightness
The brightness is set to a value of 25 by default but
it can be adjusted to a value from 0 to 50
4.2.2 Contrast
The contrast is set to a value of 25 by default but it
can be adjusted to a value from 0 to 50.
4.2.3 TV System
Select the corresponding TV system depending on
your current connection. Instead of the setup menu
and when the current screen is not visible, press the TV System button on your remote control until
you see the correct output.
HDMI: High definition multimedia interface
NTSC/PAL: Composite analogue video connection
480p ~ 1080i: YPbPr colour component video connection
Page 25