© 2014 MacroAir Technologies Toll Free: 866 668 3247 Fax: 909 890 2313 www.macroairfans.com 11
Rev. Date 111714
Components:
A - 1/4-20 x 1” Long Grade 5 Bolts (4) (not included)
B - 1/4”-20 Unistrut Channel Nuts (P3016-1420) (4) (not included)
C - Liquid Thread Lock (not included)
D - Rapid Mount Commercial
E - 1-5/8” Unistrut Pierced Channels (P1000T) (2) (not included)
F - Extension Attachment Point
This method is used to install the Rapid Mount Commercial to an I-Beam. The attachment point
to the building structure can vary greatly and we recommend Unistrut be contacted so they may
recommend the best method to attach the Unistrut to the building (www.unistrut.us). Please refer
to pg. 3 for a list of fan weights and torques.
1.2.1:
Cut two lengths of 1-5/8” Unistrut approximately 4” wider than the I-Beam or Bar Joist you
will attach the fan to.
1.2.2:
Apply the liquid thread lock to each bolt and fasten both pieces of Unistrut (open side up) to
the Rapid Mount Commercial as close to center as possible using the recommended hardware
and torque the bolts to 6ft-lbs. Recommended torque is based on 1/4-20” hardware.
1.2 I-Beam Installation (1 of 2)
A
B
C
D
E
F
Summary of Contents for 370 Airvolution D
Page 2: ......
