© 2014 MacroAir Technologies Toll Free: 866 668 3247 Fax: 909 890 2313 www.macroairfans.com 14
Rev. Date 111714
Components:
A - 1/4 x 2” (Minimum Length) Wood Lags (4)
(not provided)
B - Rapid Mount Commercial
C - Glulam
D - Extension Attachment Point
1.3.3:
Place the mount against the bottom of the beam and drive the four lag bolts into the pilot
holes but do not drive them all the way in as there needs to be roughly 1/2” of gap between the
top of the mount and the bottom of the beam to run wire and cable.
1.3.4:
Once the power wire, remote cable, and safety cable have been routed and are sitting in
their appropriate breakouts the lags can be tightened (refer to lag manufacturer for torque
specs). While tightening the lags it is recommended that you observe all wires and cables to
ensure they are not getting damaged between the mount and beam.
1.3.5:
Tighten the locking set screws on the mount once the extension attachment point is level.
Refer to page 9
for illustration.
Final Results:
1.3 Glulam/Wood Beam Installation (2 of 2)
A
B
C
D
Summary of Contents for 370 Airvolution D
Page 2: ......
