Macrom M-DVDG1CH, Instruction Manual

Change the position of the springs.

With this product, the positions of the built-in 
anti-vibration springs must be changed according
to the angle of installation. The product will not
provide the regular resistance to vibration if the
anti-vibration springs are not in the correct 
positions or if the left and right springs are in 
different positions.
The anti-vibration springs can be placed at ”H”
 or ”V” angle.
The springs are set to the”H” angle upon 
shipment from the factory. To change this angle,
follow the instructions given below.

1. Change the position 
    of the springs using
    a finger.

2. Stick on the left and
    right side surface 
    cover labels.
    Be sure to apply the
    cover labels after
    setting the position 
    of the springs so as
    to protect the interior
    of the product from dust or dirt which may cause
    malfunction.

3. Check the position of the springs. Make a final
    check of the position of the springs using the 
    five small holes in the left and right side surface
    cover labels.
 
    

H

0

90

V

0

90

H

V

Remove the shipping keys.

Three keys are mounted to the changer’s bottom
panel to protect the product during shipment. Be
sure to remove these keys before installing the 
unit. So as not to lost the keys, store them and 
cover the key holes with the included dust-
prevention seals. 

NOTES

The eject operation cannot be performed if
the keys are mounted when the power is 
turned on. Turn the power off, then remove 
the keys.

Install the L-shaped bracket.

1 Determine the position and angle installation.
2 Referring to step       , change the position of 
   the springs according to the angle of
   installation.
3 Install the L-shaped bracket  according to 
   the angle of installation. Fasten it in place
   using the Hex bolts(M5x6) 

Example of installation using attached 
L-shaped bracket. 

Vertical

Horizontal

19

NOTES

To prevent external noise from entering the 
audio system.
    Don’t connect the ground of the changer
    to the car chassis.
    Please connect the changer to the vehicle
    with the L-shaped bracket, 
    hex bolts, adhesive tape 
    and insulating pad like the
    figure shows.  
  Peel off the adhesive tapes

and press the tape onto the 
bottom of L-shaped bracket.