6
HORIZONTAL CHASES
• Horizontal chases are done from right to left.
• The right hand holds the wall chaser by the right side of the milling cutter cover and
pushes leftwards (Figure 6).
• Right arm will lean on to the machine and push also leftward from the left hand side
(Figure 7).
• The left hand holds the rear handle and operates the switch (Figure 6).
Figure 6
“Correct”
Figure 7
“Correct”
“Right hand incorrect”
HORIZONTAL CHASES CLOSE TO THE FLOOR
• Horizontal chases close to the floor are done from left to right. (Figure 8)
• Right hand holds the machine by the rear handle and operates the switch. Left hand
holds the milling cutter cover from the left hand side and pushes to the right (Figure 8)
Figure 8
“Correct”
“Both hands and the machine incorrect”
