02-18-2016
Joystick and Buttons Customization
Artwork may not be the only item you’re interested in customizing. Customization of the
joystick and buttons is made simple since you have easy access to the inside of the FightStick
and all cables are quick disconnecting wires.
The TE2+ will fit most of today’s popular joystick lever options, including SANWA and SEIMITSU.
1.
Using the flat head screwdriver tool, hold the bottom of the joystick shaft, and twist off
the joystick ball top.
2.
Remove the shaft and dust covers from the joystick.
3.
Remove the joystick harness from the joystick.
4.
Using a Philips screwdriver (not included), remove the four Philips screws and remove
joystick.
5.
Insert new joystick.
6.
Reverse instructions to re-assemble. An adapter connector harness (not included) may
be necessary.
For the buttons, the quick disconnect wires are color coded. A handy button wires chart is
provided indicating which color quick disconnect wire should go to which button. The
arrangement of this chart is the arrangement of the buttons when looking from the inside of
the FightStick.
1.
Using the flat head screwdriver tool, push inward on the small inside tabs of the button
harness quick disconnects to easily remove them from each of the eight action buttons.
2.
Carefully remove the buttons and the clear rings from the buttons.
3.
Attach the clear rings onto each of the new 30mm size action buttons.
4.
Insert new buttons.
5.
Reverse instructions to re-assemble.
For customization of the Start/Options and Select/Share button, you will need to use the hex
head screwdriver tool to undo the plastic button cover first. These use 24mm size buttons.
