WWW.MADBOY-AUDIO.COM
5
1. Connect the supplied power connector into the POWER INPUT-jack in the back of the
receiver. Insert the adapter's cable into the power cable retainer. Plug the power connector
into the wall socket or other power source. Slide the power switch to ON-position on the
back of the receiver, the red POWER light on the receiver will glow.
2. Connect the receiver's XLR AUDIO OUTPUT connector to the mixer input using an XLR
to XLR audio cable or connect 1/4" Audio output connector of receiver to the amplifier input
by a 1/4" to 1/4" phone plug cable.
3. Set position of the antennas at a 45 angle from vertical.
4. Slide the microphone’s (transmitter's) POWER ON/OFF/MUTE switch to the POWER ON
position, the LOW BATTERY indicator shines for a moment at that time, the receiver's
SIGNAL A/B lights starts to glow.
5. Talk or sing into the microphone. AF signal indicative light of receiver is glowing
according to the volume of transmitter.
6. Adjust receiving volume knob and the volume adjustment of mixer or amplifier
to get a suitable volume.
7. When the performance is over, turn OFF the sound system, receiver and slide the
micrphones’s (transmitter’s) POWER ON/OFF/MUTE switch to the OFF position.
Descriptions and getting started
Getting started
1. Turn the receiver over and locate the power cable retainer. Pinch the
AC-adaptor cord from the dc plug, forming a small loop (A). Hold the cord vertical to the
retainer and lower the tip of loop into the curved portion of retainer.
2. Keeping the cord vertical to the receiver, pull the cord under the tab towards
front of the receiver (B), then pull down, locking the cord into the retainer(C).
Cable retainer
Summary of Contents for U-TUBE 10
Page 9: ...12 WWW MADBOY AUDIO COM 7...
Page 10: ...WWW MADBOY AUDIO COM...