IMPORTANT: always use positive motor retention to secure the motor in the motor
tube. Failure to use motor retention may allow the motor to be ejected during the
ejection charge instead of the parachute, making for a dangerous ballistic reentry.
IMPORTANT: always remember to check your balance point and ensure your CG
is forward of the recommended CG point.
IMPORTANT: Always follow the NAR safety code and remember that rockets
are not toys and can be dangerous if not prepared and used properly. If you
are a beginner, it is a good idea to fly with a club or other group of experienced
rocketeers until you have gained some experience.
IMPORTANT: In no event shall Madcow Rocketry be liable for any direct, indirect,
punitive, incidental, special consequential damages whatsoever arising out of
or connected with the use or misuse of it’s products. The buyer assumes all
risk and liability resulting from ANY use of any and all products sold by Madcow
Rocketry. Your purchase and use of any Madcow Rocketry product constitutes
your agreement to and acceptance of these terms. If you do not agree to these
terms and conditions, you must return the unused product in resalable condition
for a refund or credit.
IMPORTANT: Please contact us via phone or email if you have any questions about
constructing or flying your model.
24338 El Toro Rd #E-134
Laguna Woods, CA 92637
949.547.8847
www.madcowrocketry.com
©2006 MadCow Rocketry™
®
Step 6 – Flying Your Model
Attach the end of the shock cord from the fin can to the aft eye bolt of the altimeter bay.
Also attach a second shock cord from the forward eye bolt of the altimeter bay and the
nose cone eyebolt. Attach your parachutes and chute protectors to the approriate place.
When packing your chute, wrap the chute protector around the chute with the opening in
the chute protector facing forward. Always make sure your chute is well protected as the
hot ejection motor gasses will melt the nylon chute.
