Version: User’s manual EN NF-Walker 2 ver. 2.0
Date for this version: 09.02.2017
Page 17 of 56
7.2
Height of column
Loosen the screws (2) at both sides of the frame (6 screws in total). Loosen the height
setting screw (3). Adjust the height of the column (1) and tighten all of the screws securely.
Adjustment range: The column can be adjusted within a range of approximately 130mm.
Important: Make sure that the column is at least 105mm down in the main frame. Less
intervention between the main frame and column will cause instability in the undercarriage.
Important: NF-Walker 2 must not be adjusted by persons not qualified to do so.
Important: After adjusting the height of the column, please make sure that the column is not
touching the floor when the suspension is fully compressed.
Picture no. 9 Adjustment of the NF-Walker 2’s column
Important: After adjusting the height of the column, make sure that the guide strap/elastic
are rolling freely over the roller at the U-tube. If not, correct the height of the U-tube by
adjusting the height of the U-tube clamp.
Min 105mm
2 Screw
1 Column
3 Height
setting screw