Version: User’s manual EN NF-Walker 2 ver. 2.0
Date for this version: 09.02.2017
Page 34 of 56
10.1.
Assembling
Front axle:
Place the front axle at the front axle frame part
Place the clamp over the front axle
o
Make sure that the guide screw falls into the hole in the clamp
Insert the four Unbraco screws
o
Cross-tighten the screws securely, using a 4mm Unbraco key
Rear axle:
Place the rear axle at the trailing arm
Place the clamp over the rear axle
o
Make sure that the guide screw falls into the hole in the clamp
Insert the screws
o
Cross-tighten the screws firmly, using a 4mm Unbraco key
Column:
Insert the column into the frame
o
Make sure that the height-setting screw is in contact with the frame
Tighten the 6 screws, 3 at each side of the frame securely, using a Torx key no. 30
Picture no. 47 Complete assembled undercarriage