Version: User’s manual EN NF-Walker 2 ver. 2.0
Date for this version: 09.02.2017
Page 45 of 56
12.10
Seat
The seat has multiple ways of being used:
Transfer the user standing into the brace while it’s assembled to the undercarriage
Support for the user during use
Easier transfer out from the NF-Walker 2 after use
A clamp with fixation for the height of the seat will be assembled onto the column. This clamp has 4
axles where the seat can be hooked on. These two parts will interlock together for safe operation.
The seat has an upholster to give the user comfort while sitting.
The seat can easily be disconnected from the clamp at the column by using one of your hands
pressing the handle in the front of the seat down while lifting the front end of the seat with your
other hand. This double-direction-action is a safety feature and makes it impossible for the user of
the NF-Walker 2 to disconnect the seat while she/he is sitting on it.
The height of the seat can be adjusted while the user in sitting on it by releasing the handle at the
back at the column and move it to its upper position and lift in both this handle and the handle in
front of the seat. Secure the position of the seat with first letting go of the handle at the seat and
then move the rear handle down. If the seat should slide down during use, the rear handle must be
tightened harder after moving the seat.
The seat fit all sizes of NF-Walker 2, but it requires some free space at the column.
Picture no. 66 Seat complete
MFM part name
MFM part no.
NFW 2 XS/S Seat complete
301176
Clamp
Rear handle
Upholster
Seat
Front handle
Axles
