EN
158
EN
159
Care & Maintenance
Cleaning the housing
-
Clean the housing regularly with
a moist cloth and a mild cleaning
detergent.
-
Check and clean the grille month-
ly to avoid performance reduction
due to dust and dirt.
-
Never use solvents; these could
attack the plastic parts of the
equipment.
-
Ensure that no water can seep
into the device.
Cleaning the water tank
-
Clean the water tank every 2
weeks to avoid deposit of algae,
mould or bacteria.
-
Gently pull out the water tank
from the dehumidifier and fill the
tank partly with water and a mild
cleaning detergent. Clean, empty
and rinse the water tank thoroug-
ly.
-
Do not put the water tank into
the dishwasher.
-
The water tank has to be inserted
correctly into the dehumidifier.
Cleaning the filter
-
Make sure that no dirt gets into
the appliance: Clean the supply
air grille once a month using a
soft brush.
-
Ensure that the grille is complete-
ly dry before inserting it into the
dehumidifier.
-
Do not put the grille into the dish-
washer.
Warning!
Make sure the appliance is switched off and unplugged.
Troubleshooting
Problem
Solution
The appliance doesn't
start.
-
Check if the power supply cord is inserted cor-
rectly.
-
Environmental temperature is too high or too
low.
-
The dehumidifier has reached the preset humid-
ity setting.
-
The water tank is not inserted correctly.
The appliance doesn't
dry the air as expected.
-
Time was too short.
-
Make sure the appliance is free from obstacles.
-
The humidity setting isn't set low enough.
-
Check if all windows and other openings are
closed.
-
The room temperature is too low (lower than
5 °C).
-
There is an appliance which emits water vapour
Loud sounds from the
appliance.
-
The appliance stands tilted and not upright.
-
The floor is not flat.
-
Filter is blocked. Clean filter.
Ice appears on the spools
-
This is a normal process. The appliance has an
automatic defrost.
Error and safety codes
Code
Meaning
Solution
E2
Temperature sensor is defec-
tive
Disconnect and connect the power
supply cord. If error still occurs, con-
tact your HORNBACH store
P1
Appliance is defrosting
Code will disappear automatically
when the appliance has defrosted
FL
Water tank is full or not insert-
ed correctly
Empty the water tank and insert it
correctly into the appliance
In case of service requests please contact your local HORNBACH store or
write an email to: service@hornbach.com