4. Check
the
hydraulic oil level.
5. Start engine and use the control lever to extend and retract wedge several times to remove air
from the lines.
6. With the wedge retracted, check hydraulic oil level again and fill if necessary.
WARNING
DO NOT remove the hydraulic oil fill cap when
the engine is running or hot. Hot oil can escape
causing severe burns. Always allow the log
splitter to cool completely before removing the
hydraulic
oil cap.
High fluid pressure and temperatures are created
in the hydraulic log splitters. Hydraulic fluid will
escape through a pin-size hole opening and can
puncture skin and cause severe blood poisoning.
Inspect hydraulic system regularly for possible
leaks.
Never check for leaks with your hand
while
the system is pressurized. Seek medical
attention immediately if injured by escaping fluid.
Make sure all fittings are tight and secure before applying pressure. Relieve system pressure before
servicing.
Make sure the hydraulic hoses do not touch any hot surfaces or cutting areas.
Hoses need to be positioned where they are clear from the engine and cutting wedge. To avoid
serious bodily injury always inspect the hoses before operating the log splitter.
WARNING
Before operating or using the log splitter, review the instructions below and all safety information.
Failure to follow these instructions may result in property damage or injury to the operator or
bystanders.
USING YOUR LOG SPLITTER
Press split control handle A and split control handle B at the same time as lifting wood. The chain
should be hung on the wedge hook.
Operation Instructions
Summary of Contents for LSE3502
Page 19: ...DIAGRAMA DE PE AS...
Page 41: ...DIAGRAMA PIEZAS...
Page 61: ......
Page 65: ...Parts Drawing Parts List...
