WARNING
ALWAYS
use the log splitter for its intended use.
ONLY
use the log splitter to split wood logs, length wise with the grain.
NEVER
modify, alter or change the log splitter in anyway, modifications will void the warranty.
NEVER
attach a rope, cable or other device to the control lever on the log splitter.
ONLY
operate the log splitter in daylight.
NEVER
leave the log splitter unattended while the engine is running.
DO NOT
change the splitting position with the engine running. Contact with the muffler can cause
serious burns.
ALWAYS
make sure the beam is in the locked position.
DO NOT
let the beam drop as it could crush fingers or cause damage to the log splitter.
NEVER
operate or let anyone else operate, the log splitter while under the influence of alcohol, drugs,
or medication.
DO NOT
put feet in the range of wedge activity during the operating.
STOP
engine if the wood catches the wedge and cannot be split or the wood follows the wedge up.
DO NOT
close to the lifting bracket when movement.
1. DO NOT at any time carry passengers, sit or stand on the log splitter.
2. Check the hydraulic oil level and visually inspect all hoses and attachments for problems.
3. Inspect the engine and make sure the engine oil level is correct.
4. Before towing the log splitter, the tires need to be fully inflated.
TIRE WARNING
DO NOT over inflate tires. Serious injury can result if tires explode
DO NOT tow the log splitter if the tires are worn or will not hold air.
DO NOT exceed the maximum 45 MPH towing speed.
5.
Refer to the vehicle owner’s manual for proper safety and
towing instructions.
TOWING WARNING
Serious injury or death can occur if towing safety rules are not followed.
Always check the ball coupler and wheels to make sure all hardware is secure before towing.
Before towing a long-distance check to make sure the axle nuts and pins are tight and securely in
place.
Always use safety chains, secure and lock the log splitter to the vehicle hitch before moving.
Drive safely. Be aware of the added length of the log splitter.
Never exceed the maximum travel speed of 45 mph.
Never ride or transport cargo on the log splitter.
Turn off the vehicle before leaving the log splitter unattended.
Block the log splitter wheels to prevent unintended movement.
6. The log splitter must have at least seven feet of clearance from combustible material. It needs
to be on a dry and level surface with good footing. Do not work on mud, ice, brush or snow.
When using the log splitter, the work zone must be maintained at all times.
Summary of Contents for LSE3502
Page 19: ...DIAGRAMA DE PE AS...
Page 41: ...DIAGRAMA PIEZAS...
Page 61: ......
Page 65: ...Parts Drawing Parts List...
