B
Connect the other end to a USB
port on your PC. When the
IFC200
is plugged in, the
Found
New Hardware Wizard
will pop
up. Select the
No, not this time
option to not allow Windows to
connect to Windows Update. Click
the
Next
button to continue.
C
When prompted for the installation
CD, select the
Install the
software automatically
option.
Click the
Next
button to continue.
N
OTE
: the CD is not necessary for
this step to complete.
D
When using Windows XP, a screen
may appear indicating,
the
software has not passed
Windows
®
Logo testing
. This
software has been tested and
works properly with Windows XP.
Click the
Continue Anyway
button to complete the installation.
E
When the installation is complete,
the
Found New Hardware
Wizard
will reappear stating that
it has finished installing the
software for the USB Datalogger
Interface. Click the
Finish
button
to exit the Wizard.
B
The blue power LED indicator light
on the IFC200 should be on.
If the blue LED indicator light is
NOT
on, unplug the USB cable
from the IFC200. Wait 5 seconds,
then plug the USB cable into the
IFC200.
C
Start the MadgeTech Data
Recorder Software.
If necessary, see the software
manual for additional information
on the software.
D
From the
Communication
menu
on the toolbar choose
Select
Comm Port
from the drop down
list.
A sub-menu will appear listing the
software available communication
ports. If the IFC200 installation
was successful and the device is
plugged into the computer, the
menu option of USB1 should
appear. If multiple IFC200 devices
are plugged into the same PC,
they will all be listed in this menu
as USB1, USB2, USB3, ... etc. Use
this menu to select the proper
device.
E
As with the standard COM port
the IFC200 must be configured to
communicate at the proper baud
rate. The IFC200 can be
configured to work with most
MadgeTech Data Loggers by
selecting the proper baud rate in
the software. The baud rate will
be dependent on the baud rate of
the device connected to the host
computer. For example, a
Temp101 communicates at 2400
baud, so 2400 baud must be
selected from the
Communication
menu.
D
E
Additional Information
For additional information or troubleshooting assistance, refer to
the User Guide on the Data Recorder Software CD-ROM. You can
also call or e-mail for further support.
E
D
C
B
A
To verify that the IFC200 drivers
were installed properly, check to
ensure the Data Recorder
Software can recognize the
device.
Test USB Interface Device Operation
3
Website
http://www.madgetech.com
E-mail Support
support@madgetech.com
Phone
(603) 456-2011
Fax
(603) 456-2012
Address
MadgeTech, Inc.
P.O. Box 50
201 Route 103 West
Warner, NH 03278
Congratulations!
The installation of the
IFC200 USB Data Logger
Interface is complete!
