RFC1000
Channel 11
Channel 12
Channel 13
Channel 14
Channel 15
Channel 16
Channel 17
Channel 18
Channel 19
Channel 20
Channel 21
Channel 22
Channel 23
Channel 24
Channel 25
Channel 26
(not supported)
Channel Programming
The RFC1000 transmits data on the 2.4 GHz band and is programmed by default on
channel 11. Each MadgeTech Wireless Data Logger and RFC1000 has a set of dip switches
with which the channel may be programmed.
Different wireless channels may be used to create multiple networks in one area, or to avoid
wireless interference from other devices. Any MadgeTech data logger or RFC1000 that is on
the same network is required to use the same channel. If all of the devices are not on the
same channel, the devices will not communicate with one another.
The images below show the orientations available of the switches for each channel. Channel 26
(all switches in the up position) is not supported.
11
Follow the instructions below to configure the channel settings of the RFC1000
1.
To program the channel on an RFC1000, first unplug the RFC1000.
2.
Use a Phillips head screwdriver to unscrew the enclosure.
3.
Find the dip switches located on the front of the PCB circuit board.
4.
Change the dip switches to match the desired channel using the diagram above.
5.
Screw the enclosure back together and reconnect the RFC1000.
Close-up
