PR1000IS
NEED HELP?
Device Maintenance
O-Rings
O-ring maintenance is a key factor when properly caring
for the PR1000IS. The O-rings ensure a tight seal and
prevent liquid from entering the inside of the device.
Please refer to the application note
O-Rings 101:
Protecting
Your
Data
,
found
, for information on how
to prevent O-ring failure.
Recalibration
MadgeTech recommends annual recalibration. To send
devices
back
for
calibration,
visit
pacificsensortech.com.au/calibration
Battery Replacement
Materials:
TL-2150/S Battery
1.
Move device to a non-hazardous
location before replacing
battery.
2.
Observe Operational Warnings
when removing and replacing
the battery.
3.
Unscrew the bottom of the data
logger and remove the battery.
4.
Place the new battery into the
logger.
Caution: Observe correct
battery polarity when installing.
It is important to insert the battery with the positive
polarity pointing upwards towards the sensor.
5.
Screw the cover onto the data logger.
Product Support & Troubleshooting:
•
•
Contact our friendly Customer Support Team at 1300 662 720 or
sales@pacificsensortech.com.au
MadgeTech 4 Software Support:
•
Refer to the built-in help section of the MadgeTech 4 Software.
•
Download the MadgeTech 4 Software Manual at
pacificsensortech.com.au/madgetech-4-software
•
Contact our friendly Customer Support Team at 1300 662 720 or
sales@pacificsensortech.com.au
.
AUTHORIZED DISTRIBUTOR IN AUSTRALIA
Pacific Sensor Technologies Pty Ltd
.
Unit 4, 3 Neutron Place, Rowville VIC3178 Australia
1300 662 720
