PR2000
10
Recalibration
The PR2000 standard calibration is dependent upon the range.
Additional:
Custom calibration and verification point options available, please call for pricing.
Call for custom calibration options to accommodate specific application needs.
Prices and specifications subject to change. See MadgeTech’s terms and conditions at
madgetech.com
To send devices to MadgeTech for calibration, service or repair, please use the MadgeTech RMA Process by visiting
madgetech.com
, then under the services tab, select RMA Process.
Device Maintenance
Materials:
3/32” HEX Driver (Allen Key) and Replacement Batteries (6AA)
- Remove the back cover from the device by unscrewing the four screws.
- Remove the battery from its compartment and unsnap it from the connector.
- Snap the new battery into the terminals and verify it is secure.
- Replace the cover taking care not to pinch the wires. Screw the enclosure back together.
Note: Be sure not to over tighten the screws or strip the threads.
For any other maintenance or calibration issues, we recommend the unit be returned to the
factory for service. Before returning the device, you must obtain an RMA from the factory.
Battery Replacement
This product does not have any user-serviceable parts except the battery which should be
replaced periodically. The battery life is affected by battery type, ambient temperature,
sample rate, sensor selection, off-loads and LCD usage. The device has a battery status indi-
cator on the LCD. If the battery indication is low, or if the device seems to be inoperable, it
is recommended that the battery be replaced.
