MadgeTech RFC1000-IP69K, User Manual

Product User Guide

6

Configuring the Channel Settings of the RFC1000-IP69K

1. 

Unplug the RFC1000-IP69K. 

2. 

Use a Phillips head screwdriver to unscrew the back of the RFC1000-IP69K enclosure.

3. 

Find the DIP switches located on the front of the PCB circuit board 

(diagram 1a)

. 

4. 

Change the DIP switches to match the desired channel 

(diagram 1b)

. 

5. 

Screw the RFC1000-IP69K enclosure back together.

6. 

Reconnect the RFC1000-IP69K.

Different wireless channels may be used to create multiple networks in one area, or to 
avoid wireless interference from other devices. Any RFC1000-IP69K wireless transceiver or 
MadgeTech data logger on the same network is required to use the same channel. If all of the 
devices are not on the same channel, the devices will not communicate with one another. 

The RFC1000-IP69K is programmed by default on channel 25

.

Channel Programming

CHANNEL NOTE: MadgeTech wireless data loggers and RFC1000 wireless transceivers purchased 
prior to April 15, 2016 are programmed by default to channel 11. Please refer to the Product User 
Guide provided with these devices for instructions to change the channel selection if needed.

1a.

DIP Switches