PRODUCT USER GUIDE
RTDTemp101A
DOC-1216035-00 | REV 11 2020.05.27
NEED HELP?
Product Support & Troubleshooting:
• Visit our Resources online at
.
• Contact our friendly Customer Support Team at
01929 459 459 or support@wpls.co.uk
MadgeTech 4 Software Support:
• Refer to the built-in help section of the MadgeTech 4 Software.
• Download the MadgeTech 4 Software Manual at
• Contact our friendly Customer Support Team at
01929 459 459 or support@wpls.co.uk
LED Indicators
Green LED blinks:
10 seconds to indicate
logging and 15 seconds to indicate delay
start mode.
Red LED blinks:
10 seconds to indicate
low battery and/or memory and 1 second
to indicate an alarm condition.
Multiple Start/Stop Mode Activation
•
To start device:
Press and hold the pushbutton for
5 seconds, the green LED will flash during this time. The
device has started logging.
•
To stop the device:
Press and hold the pushbutton for
5 seconds, the red LED will flash during the this time.
The device has stopped logging.
Device Maintenance
Battery Replacement
Materials: Small Phillips Head Screwdriver and a
Replacement Battery (LTC-7PN)
1. Puncture the center of the back label with the screw
driver and unscrew the enclosure.
2. Remove the battery by pulling it perpendicular to the
circuit board.
3. Insert the new battery into the terminals and verify it
is secure.
4. Screw the enclosure back together securely.
Note:
Be sure not to over tighten the screws or strip the threads.
Recalibration
Recalibration is recommended annually. To send
devices back for calibration, visit
support@wpls.co.uk or
call 01929 459 459.
