Product User Guide | 3
VFC2000
PRODUCT USER GUIDE
Device Maintenance
Battery Replacement
Materials:
U9VL-J Battery or any 9 V Battery
1. On the bottom of the data logger, open the battery
compartment by pulling in on the cover tab.
2. Remove the battery by pulling it from the
compartment.
3. Install the new battery, taking note of the polarity.
4. Push the cover closed until it clicks.
Recalibration
Recalibration is recommended annually or bi-annually for
any data logger; a reminder is automatically displayed in
the software when the device is due. To send devices back
for calibration, visit
.
LED Indicators
Status:
Green LED blinks every 5 seconds
to indicate the device is logging.
Check:
Blue LED blinks every 30 seconds to
indicate daily statistic check has gone past
24 hours. Hold Scroll button for 3 seconds to
reset reminder.
Alarm:
Red LED blinks every 1 second to
indicate an alarm condition is set.
Product Support & Troubleshooting:
• Refer to the Troubleshooting section of this document.
• Visit our Knowledge Base online at
• Contact our friendly Customer Support Team at (603) 456-2011 or
.
MadgeTech 4 Software Support:
• Refer to the built-in help section of the MadgeTech 4 Software.
• Download the MadgeTech 4 Software Manual at
• Contact our friendly Customer Support Team at (603) 456-2011 or
.
