PLEASE READ THE MANUAL CAREFULLY BEFORE
INSTALLATION & OPERATION AND RETAIN IT FOR
FUTURE REFERENCE.
Adherence to the directions for use in this manual is
extremely important for health and safety. Failure to
strictly adhere to the requirements in this manual
may result in personal injury, property damage and affect
your ability to make a claim under the manufacturer’s
warranty provided with your product. Products must be
used, installed and operated in accordance with this
manual. You may not be able to claim on the manufactur-
er’s warranty in the event that your product fault is due to
failure to adhere this manual.
CONTENTS
1.1 When installing and using this electrical equipment,
basic safety precautions should always be followed,
including the following:
Fill the pump with water before starting. Do not run the pump
dry. In case of dry run, mechanical seal will be damaged and
the pump will start leaking.
Before servicing the pump, switch OFF power to the pump by
disconnecting the main circuit to the pump and release all
pressure from pump and piping system.
Never tighten or loosen screws while the pump is operating.
E
This pump must be equipontental bonded to local and national
regulations.
nsure that the inlet and outlet of the pump are unblocked
with foreign matter.
1. IMPORTANT SAFETY INSTRUCTIONS
2. TECHNICAL SPECIFICATIONS
3. OVERALL DIMENSION
4. INSTALLATION
4.1 Tools required
4.2 Pump Location
4.3 Piping
4.4 Valve and Fittings
4.5 Check before initial startup
4.6 Application conditions
5. SETTING AND OPERATION
5.1 Display on control panel
5.2 Startup
5.3 Self-priming
5.5 Timer mode
2
3
3
3
3
4
4
4
4
4
5
5
5
5
6
6. EXTERNAL CONTROL
a.
7. PROTECTION AND FAILURE
7.1 High Temperature Warning and
Speed Reduction
7.2 Undervoltage protection
7.3 Troubleshooting
7.4 Error code
8. MAINTENANCE
10. DIAGRAM
9. DISPOSAL
7
7
8
8
8
8
8
9
10
1.2 All installations must be
fi
tted with earth leakage or residual
current protection devices, having a rated residual operating
current not exceeding 30mA.
1. IMPORTANT SAFETY INSTRUCTIONS
This guide provides installation and operation instructions for this pump.
If you have any other questions about this equipment, please consult
your supplier.
9
11. WARRANTY & EXCLUSIONS
11
5.6 Parameter settings
6
RISK OF ELECTRICAL SHOCK.
Pool pump must be installed on a RCD protected circuit.
Check your local state regulations and wiring rules.
Th
This water pump must be earthed in accordance to local
and national regulations. Earthing point is clearly labelled
on pump
is pump is for use with permanently installed in-ground
or above-ground swimming pools and may also be used
with hot tubs and spas with a water temperature under
50°C. Due to the
fi
xed installation method, this pump is
not suggested to be used on above-ground pools that can
be readily disassembled for storage.
The pump is not submersible.
Never open the inside of the drive motor enclosure.
2
INVER
FLOW
Digital input
5.
6
4 Running Capacity Setting
Summary of Contents for invermac inverFLOW INVFLO300
Page 1: ...Powered by INSTALLATION MANUAL...
Page 12: ...AG045 DE 05...