Madison Electric Products, Inc
.
26401 Fargo Avenue • Bedford Heights, OH 44146 • P: 1-800-631-7775 • F: 1-216-391-7912
© 2015/02032
Frame
Connector
Washers (D)
Carriage
Bolts (C)
Lock Nuts
Reel Shafts
Hitch Pin
Clip (F)
Wire
Spool
Reel
Shaft
Reel Shaft
Support Frame (B)
Support Frame (B)
Handle (A)
Handle (A)
Push
Down
Top View
FIGURE 2
FIGURE 1
FIGURE 3
ASSEMBLY INSTRUCTIONS
FIGURE 1
Place the Handle (A) onto the Support Frame (B)
connector. Make sure that the reel shaft is facing toward
the inside. Push down firmly until Handle (A) is seated
against Support Frame (B). Repeat for the opposite side.
FIGURE 2
Fasten Handle (A) to Support Frame (B) using the 1/4-20 x
1 1/4” Carriage Bolts (C), 1/4” x 1/2” Flat Washers (D), and
1/4 x 20 Nylon-Insert Locknuts (E). Repeat for the opposite
side.
FIGURE 3
Load wire spools onto Reel Shafts and secure using Hitch
Pin Clips (F). Load spools from the inside out. For best
results, when using multiple spools, balance the load
equally on both sides.
