15
GENERAL OPERATION (CONT’D)
OPERATING THE VEHICLE:
1. After performing all pre-drive checks, ensure that the vehicle park brake is engaged and the Run/Tow
switch underneath the passenger side of the front seat is in the Run position.
2. Insert the key into the ignition and turn it ON. Turn the RND knob to D for forward or R for reverse.
3. Slowly press the accelerator pedal and begin driving.
4. When stopping or slowing down, slowly release the accelerator pedal, then slowly apply the brake pedal
as needed. Always come to a complete stop and press and hold the brake pedal before changing from
forward and reverse directions.
5. When steering, slow down as necessary to safely make the turn. Turning too sharply may cause a loss of
control.
SETTING PARK BRAKE:
Bring the vehicle to a complete stop, then turn the key to OFF.