34
CONTROLLER FAULT CODES
If the controller experiences a fault, the LED on the controller will flash the number of times in the “Flash”
column below. To view the LED, remove the Phillips head screws on the controller cover (where the Run/Tow
switch is located).
If the vehicle is equipped with an LCD display, the display will show the code in the “LCD Display” column.
Flash
LCD Display
Fault
Solution
1
F01
High Pedal Disable
Release the accelerator. Turn the key off, then back on without pressing pedal.
4
F04
Controller Overheat
Shutdown vehicle. Wait several minutes for controller to cool down, then turn on key
switch. The controller will restart.
5
F05
Main power outage
Check the battery to controller
connection.
6
F06
Current sampling
circuit error
Restart controller. If this does not work,
replace controller.
7
F07
Encoder failure
Check the motor encoder. If this does not
work, replace motor.