MADRAX MADLOCKER ™ Assembly Instructions
MADRAX DIVISION
ML1-1 and ML2-2
GRABER MANUFACTURING, INC.
3/30/18
Page 1 of 7
GENERAL INSTRUCTIONS
1.
Handle with care so that the painted surfaces are not marred.
2.
Leave all fasteners loose until instructed to tighten.
3.
Take care to not cross thread fasteners.
4.
All fasteners are ¼”
-
20 x ½” Stainless Steel Button Head Screws, except for the leveling
hardware and the hardware used to attach the lock handle.
TOOLS NEEDED
5/32” and 1/8” Hex Allen Wrenches
3/8” Open End Wrench
7/16” Open End Wrench
3/4” Open End W
rench
8” Adjustable Wrench
Straight Tip Screwdriver
Padding to protect painted surfaces during assembly
MATERIALS INCLUDED IN KIT
1/4
”
-20 x 1/2
” Button Head
3/8” x 5" Anchor Spikes
1/2
”
-13 Nut
1/2
”
-13 x 3 1/2
” Carriage Bolt
1/4
” Flat Fender Washer
1/4
”
-20 x 1" Button Head Socket Cap Screws
10-24 Nylon Nuts
10-24 x 3/4
” Tamper Resistant Screws
1/4"-20 Hex Nut
STEP 1
Assemble the
DOOR PANEL(S)
with the
CAM AND LOCKING BAR ASSEMBLY(S)
and the
LOCK AND
HANDLE ASSEMBLY(S)
on a padded surface, face down. Allow the handle(s) to extend over the
edge of a work surface for ease of assembly.
Insert the bottom lock bar(s) first, then the top. See handle assembly illustrations below for order
of assembly. Assemble the appropriate handle with
10-24 x 3/4" Tamper Resistant Screws
and
10-24 Nylon Nuts.
Padlock / U Lock Handle Assembly
Pop Out T Handle Assembly
