STEP 6 - Windshield Installation
The windshield attaches to the brackets
with T-screws that have hard rubber
washers on the front side of the
windshield, and soft rubber washers on
the inside. Pre-assemble all four screws
and washers into the windshield holes
(as shown the diagram at right) before
attaching the windshield to the
MadStad brackets. The well nuts are
flexible and the shield holes are oversized so you can nudge the shield and
screws around to get them into the well nuts. Once that’s done go ahead and
screw the four screws down until they are snug, which means the screw tip has
gone past the back of the well nut, the well nuts have swelled up a bit and the
shield is resting snugly against the brackets.
DO NOT OVERTIGHTEN!
Over-
tightening can damage the rubber well nuts.
The final installation
should look like this:
