Adjusting the MadStad Knob Brackets
The knob screws release the brackets allowing the windshield to slide and tilt.
These knob screws must always be tightened securely before riding. DO NOT
attempt to adjust the brackets while riding! You must come to a complete stop
before making adjustments. Also make sure that you do not set the windshield
in such a way that causes your handlebars or hand guards (if installed) to hit the
windshield when turning, or before reaching full lock.
To make adjustments, loosen the knobs 1-2 turns and set the windshield so the
top edge is at about your chin level as you look straight ahead while seated on
the bike. Set the angle at approximately 60 degrees (roughly the same angle as
your forks). You can also use the angle diagram on the back page of this
manual as a guide. Tighten the knobs and go for a ride to see if you now have
smooth airflow over and around your helmet. Do this on a calm day if at all
possible; windy days make it hard to judge the airflow. Don’t ever try to adjust
the brackets while in motion!
To try a different windshield position, bring the motorcycle to a complete stop
and out of traffic. Loosen the two knob screws and tilt the windshield forward
or back 2-3 degrees or so, and/or adjust it up or down if necessary. Re-tighten
the knobs and go for another ride.
Continue experimenting with different positions at different speeds until you
find a combination of height and rake angle that eliminates buffeting and gives
a smoother ride. You may have more than one favorite position, for example
shield tilted forward on cooler days, and shield tilted back for hot days to let
more air to your body.
Bottom deflector
The center deflector is designed to block a jet of air that shoots up from in front
of the fuel tank and hits you in your body. You do not have to use this
deflector, however most likely it will give you a calmer and quieter ride,
particularly at highway speeds. Using the T-screws provided you can easily
remove or install it at will.
