7
- Unwind the power cord completely.
ATTENTION!
A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
Open the handle (E/Pic.1), until the folding mechanism gets in to
the lock position (С/Pic.1).
- Before switching on the hairdryer to the power supply, make sure
that the device switch (A / Pic.1) is set to “0” (OFF).
- Connect the device to the power supply.
- Choose the desired operating mode by the Switch (A /Pic.1):
CAUTION:
If the hairdryer stopped its work for an unknown reason,
just set the switch A to position “0” off and unplug the device.
Let it cool down. Then check the air intake grille, and in case of
contamination clean it or hold the hairdryer a little further away from
the hair while operation.
EN
Position
of the switch
Designations
Function
А0
0
(OFF) - the device is switched off
А1
1
First rate uses half of the power
of the device, used for delicate
hair drying and for modeling.
А2
2
The second speed includes the
entire capacity of the device and
is used for rapid hair drying.
Summary of Contents for MR 203
