Maestro MR045, Owner'S Manual

8

9

- Connect the plug to the mains.
- Remove the kettle from the support.
- Press the button to open the cover, the cover will open. 
-  Fill the kettle with cold water up to the mark «MAX». Close the 
cover (until it clicks). 
- Place the kettle on the support.
 - Turn the switch (C/ Fig.1) to the position «I». The indicator will 
light signaling that the device has turned on, and the kettle shall 
begin warming the water.
- When the water begins to boil, the switch will be turned to 
the position «О» (off), the light will fade and the kettle will be 
automatically turned off. 
- You must pour out the first portion of water and repeat the boiling 
procedure again.
- Now the kettle is ready for use. 

ATTENTION!

 Do not fill the kettle with cold water until cools down; 

let it get cool before filling with cold water. 

The taste of plastic

- Usually the taste of plastic appears during the first boiling.
- Pour out the water boiled for the first time and repeat the 
procedure several times.
- If the taste of plastic persists, fill the kettle with water till the mark 
«MAX» and add 2 tea-spoons of soda. Boil the water and pour it 
out.

Further boil water as specified above. 

The level of water in the kettle must be somewhere between the 
marks «MIN» and «MAX».
The process of warming the water can be interrupted at any 
moment by pressing on the switch.

ATTENTION! 

If your kettle switches off before the water begins 

to boil, you should clean it of scale (see cleaning and 
maintenance). The kettle can continue operation if its cover 
is open.

Cleaning and maintenance

Regular cleaning improves the performance of the device.
The quantity and the speed of forming the scale, and consequently, 
the necessity of cleaning depend on the water hardness in your 
region and the intensity of the device usage. All over fur of scale in 
your kettle is not allowed!
It is recommended to clean the kettle at least 2 times a year but 
however until the appearance of all over scale.

ATTENTION!

- Never clean a kettle connected to mains.
- Before cleaning, disconnect the kettle and let it cool down.
- Do not use abrasive and aggressive detergents.
- Never submerge the kettle, its support, power line cord and plug in 
water or other liquids.

Cleaning the filter (for the models with removable filter)

-Clean the filter from lime scale with a nylon brush under a flow of 
water. Soak dirty filter in vinegar or special liquid for removing the 
scale before cleaning.

Cleaning the kettle from scale

Clean the kettle from scale with special agents sold in the open 
market. Cleaning from scale can be also performed by the methods 
described below:
    

METHOD 1

- Fill the kettle to maximal level with a mixture consisting of 1 part 
of usual vinegar and 2 parts of water. Switch on the kettle and let is 
boil and automatically switch off.

EN