8
cut” to “longer cut“ a couple of times. Doing this each time after you
have finished using your clipper will help to keep the blades clear. If
your clipper stops cutting and this does not help, your cutting blades
are dulled. Replace them with new blades.
Preparation for use
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
- Inspect the clipper, making sure that it is free of oil between the
cutting blade teeth and turn the unit on to distribute the oil and to
make sure it is running smoothly. Wipe off any excess oil. This
should be done before each use.
-While using the unit, untwist the cord from time to time to avoid
tangling.
- Seat the person so their head is approximately at your eye level.
This allow ease of visibility while cutting and a relaxed control of the
unit
- Before cutting always first comb the hair so it is tangle free and as
it is naturally worn.
Reminders
- Cut the hair in a relaxed and slow manner. Use short strokes only
to work gradually over the entire head.
- Always take off a little hair at a time; you can always trim off
additional hair later.
- As you work, comb the hair frequently back into the style to which
you are cutting.
- When cutting with this hair clipper it is better to leave the hair dry,
not wet. With the hair dry, it is much easier to control the amount of
hair being cut.
Attachment Combs
(see main diagram).
Each comb attachment is marked accordingly on its outside middle
Summary of Contents for MR656C
