-32-
Danger
The warning light 25 (Fig. 1)
indicates the rotation of the tool by
means of an “orange” signal. The
warning light 25 switches off when
the tool is stationary. Now you can
pull the machine back into the
starting position. As long as the
signal glows, you may not lift the
machine off the workpiece or pull it
back.
5.11
Working with position indicator (for KSS-
guiding device and F-rail)
Use position indicator 29 (Fig. 3) to
align the KSS-guiding device. The
position indicator shows the right
side of the milling cutter, set the
position indicator to the same angle
as the machine. The position
indicator is enclosed with the
machine.
Follow the procedure below:
•
Fasten the position indicator 29 with the wing
bolts 9 (Fig. 3).
•
Set the position indicator 29 to the same angle
as the machine tilt. You can also determine the
position of position indicator 29 by means of an
auxiliary milling groove in the tool.
•
The angle scaling refers to the right side of the
milling head.
•
Set the required milling depth and machine the
workpiece.
5.12
Working with the lateral stop in combination
with KSS-guiding device
The lateral stop 50 (Fig. 4) is used to work parallel to
an already existing groove. Lock the stop in the guide
groove of the KSS-rail. The lateral stop is preset to
approximately 625 mm, fine adjustment at the stop is
possible.
Different rafter spacings can be set via the markings
X and Y at the face edge stop:
X = 625 mm with 60 mm milling head
Y = 600 mm with 46 mm milling head
Follow the procedure below:
•
Unfasten the locking screw 53 with the wrench
AF 5 that is kept on the position indicator.
•
Turn the adjusting screw 54 in the
corresponding direction.
•
Retighten the locking screw 53.
6
Service and maintenance
Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
Check the braking effect of your machine at regular
intervals. If the braking effect worsens, always
contact your MAFELL after-sales service to have the
braking system serviced.
In order to check the safety functions, the machine
must be handed in at a MAFELL service workshop for
inspection at the latest after 3 years of use.
6.1
Storage
If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
Store the machine only in dry rooms and protect it
from the effects of weather.
6.2
Tools
The milling heads used on the machine should be
regularly deresinified, as clean tools improve the
cutting quality.
Deresinify them by placing them in petroleum or a
commercially available deresinification agent for 24
hours.
