-19-
7 Troubleshooting
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution.
If the machine switches off automatically, the electronic system has activated self-protection mode.
Despite this protective function, overload and as a consequence damage to the machine may occur during
certain applications.
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Cause
Remedy
Rechargeable battery almost empty
Electronic system protects the
rechargeable battery from deep
discharge.
If only one LED is still glowing,
recharge
the
rechargeable
battery.
Only one LED is still glowing.
Charge the rechargeable battery.
Overload, machine switches off.
A sustained load has overheated
the machine or the rechargeable
battery. A warning signal is
sounded (constant bleeping).
This sound stops after max. 30
seconds or when the switch
trigger is released (15).
Allow the machine and the
rechargeable battery to cool
down. The machine can also be
cooled down much faster by
using a different rechargeable
battery and idling the machine.
The machine can also be cooled
down much faster by using a
different rechargeable battery and
idling the machine.
Machine switches off in case of
excessive load.
An excessive current rating, such
as occurs during a longer lasting
blockage, will cause the machine
to switch off.
Switch off the machine by
releasing the switch trigger (15).
Afterwards, you can switch the
machine back on again and
resume work as normal.
Try to avoid further blockages.
8 Optional accessories
-
Rechargeable battery 10 M 22
Order No. 904444
-
Rechargeable battery 10 M 43
Order No. 094445
-
APS 10 M charger
Order No. 094447
-
APS 10 M charger - GB
Order No. 094448
-
Angle attachment A-WV 10
Order No. 206773
-
Chuck A-BF 10
Order No. 206771
-
Quick bit holder A-BH
Order No. 206766
