KSS40 18 M bl
12
01/2022
-
To restart a saw that sits in the workpiece, center the saw blade in the kerf and ensure that the saw
teeth are not jammed in the workpiece.
A jammed saw blade can move out of the workpiece or cause a
kickback when the saw is restarted.
-
Support large panels to reduce the risk of a kickback from a jammed saw blade.
Large panels tend to
sag under their own weight. Panels must be supported on both sides: near the kerf and at the edge.
Fig. 5: Incorrect support vs. correct support
-
Never use blunt or damaged saw blades.
The kerf produced by a saw blade with blunt or incorrectly
aligned teeth is too narrow, causing increased friction, jamming of the saw blade and kickback.
-
Prior to starting sawing, tighten the cutting depth and cutting angle settings.
If the settings change
during the sawing process, there is a risk of a jamming saw blade and kickback.
-
Be particularly careful when sawing into existing walls or other concealed areas.
The saw blade can
jam and cause kickback when cutting into hidden objects.
Function of the lower guard
-
Before each use, ensure that the guard is closed properly. Never use the saw if the guard cannot
move freely and does not close instantly. Never clamp or tie the guard. This would leave the saw
blade unprotected.
The guard can be bent if the saw drops to the ground. Ensure that the guard moves
freely and does not get in contact with the saw blade or other parts at all cutting angles and cutting depths.
-
Check the function of the spring for the lower guard. Have the saw serviced before use if lower
guard and spring do not function properly.
Damaged parts, sticky deposits or accumulations of chips
delay the operation of the lower guard.
