-12-
1.4
Noise emission
Noise emission values determined according to EN 60745-1:
The noise measurements were recorded using the disk cutter included in the standard equipment.
The stated values do not take any series variance into account and are not suitable for determining the immis-
sion sound power level, since this varies depending on the operating time, the machining operation concerned
and environmental factors. The immission sound power level can consequently be determined only in the indi-
vidual instance on the premises of the machine user.
1.5
Vibration
The typical hand-arm vibration is less than 2.5 m/s
2
.
1.6
Delivery specification
Biscuit Jointer LNF 20 complete with:
1 disk cutter
1 ejection pipe
1 hose connector
1 dust bag, complete
1 cutter guard stop
1 mains cable 4 m (13.1 ft)
2 service tools
1 carrying case
1 operating manual
1 folder „Safety instructions“
1.7
Use according to intended purpose
The MAFELL Biscuit Jointer LNF 20 is intended
exclusively for cutting grooves on solid timber, ply-
wood, particle boards, fiber boards, perspex and
artificial marble for biscuit sizes 0, 10, 20, S6, Sim-
plex und Duplex.
Any use beyond this scope is considered as failing
to comply with the intended purpose. The manufac-
turer is not liable for any damage caused as a result
of this; the risk is borne solely by the user.
The machine is not suitable for operation in the rain
outdoors or in areas subject to explosion hazards.
Use according to intended purpose also includes
compliance with the operating, maintenance and
repair conditions specified by MAFELL, and adher-
ence to the safety instructions contained in the oper-
ating manual.
The Biscuit Jointer LNF 20 may only be used, set up
and serviced by persons over 18 years of age who
are familiar with the machine and have been
instructed as to the dangers involved. Repair work
must be carried out by authorized MAFELL dealers
or a MAFELL customer service station.
The safety regulations applicable in the country of
use, as well as all other generally accepted rules on
safety and occupational medicine, must be
observed.
Unauthorized modifications to the machine preclude
the liability of the manufacturer for any resultant
damage.
1.8
Residual risks
³
Touching the disk cutter outside the support.
³
Parts of the disk cutter breaking and slipping
out.
Sound power level
Workplace-related
emission value
No load
93 dB (A)
83 dB (A)
Residual risks may also arise owing
to the design of the machine relat-
ing to its intended purpose even if
the machine is used properly and in
compliance with all relevant safety
regulations; e.g.:
