TDC series user manual rev 1.0
11
M
A
G
T
H
E
A
TR
O
N
1. Safety instructions
1. Read these instructions carefully.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this equipment near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install
following the manufacturer’s instructions.
8. Do not use near heat sources such as stoves, heat
registers, radiators, or other equipment (including
amplifiers) that produces heat.
9. Do not use the unit near open fire sources.
10. Connect the unit only to the electric network
with grounding. Use only electric plugs that provide
grounding.
11. Protect the power cord from being walked on,
pinched, or otherwise damaged.
12. Use only accessories specified by the
manufacturer.
13. Unplug this unit during lightning storms or when
unused for long periods.
14. Refer all servicing to qualified service personnel.
Servicing is required when the system has been
damaged in any way, such as a power supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the unit, the unit has been exposed
to rain or moisture, does not operate normally, or
has been dropped.
15. WARNING - TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS SYSTEM
UNIT TO RAIN OR MOISTURE.
THIS UNIT CONTAINS POTENTIALLY LETHAL
VOLTAGES. TO PREVENT ELECTRIC SHOCK OR
HAZARD, DO NOT REMOVE THE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
INSTALLING OF THIS UNIT MUST BE PERFORMED
ONLY BY QUALIFIED TRAINED PERSONNEL
FOLLOWING APPLICABLE SAFETY RULES.
DO NOT ALLOW INSTALLATION OF THIS UNIT
IF INSTALLATION HARDWARE IS BROKEN,
BENT, PARTS ARE MISSING OR IS OTHERWISE
DAMAGED.
The triangle with the lightning bolt is used to alert
the user to the risk of electric shock.
The triangle with the exclamation point is used
to alert the user to important operating or
maintenance instructions.
The CE mark indicates compliance with low voltage
and electromagnetic compatibility.
The symbol for earth/ground connection.
The symbol indicating that the equipment is for
indoor use only.
The symbol for conformity with Directive
2002/96/EC and Directive 2003/108/EC of the
European Parliament on waste electrical and
electronic equipment (WEEE).
WARNING: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT ATTEMPT TO OPEN ANY PART
OF THE UNIT. NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
TO COMPLETELY DISCONNECT THIS APPARATUS
FROM THE AC MAINS, DISCONNECT THE
POWER SUPPLY CORD PLUG FROM THE AC
RECEPTACLE.
THE MAINS PLUG OF THE POWER SUPPLY CORD
MUST REMAIN READILY ACCESSIBLE.
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE, DRIPPING OR SPLASHING LIQUIDS.
OBJECTS FILLED WITH LIQUIDES, SUCH AS
VASES, SHOULD NOT BE PLACED ON THIS
APPARATUS.
WHEN THE UNIT IS INSTALLED IN RACK
CABINET OR A SHEFL, MAKE SURE THAT IT HAS
SUFFICIENT SPACE ON ALL SIDES TO ALLOW
FOR PROPER VENTILATION (50 CM FROM THE
FRONT AND REAR VENTILATION OPENINGS).
CONNECTIONS TO THE MAINS SHALL BE DONE
ONLY BY AN ELECTRO TECHNICALLY SKILLED
PERSON ACCORDING TO THE NATIONAL
REQUIREMENTS OF THE COUNTRIES WHERE
THE UNIT IS SOLD.
EXPLANATIONS OF GRAPHICAL SYMBOLS
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
SA
FE
T
Y
IN
STR
U
C
TI
O
N
S
