11
in
fo@mag-audio
.c
om
Tel./F
ax:
+38 044 277
-4
7-89
www
.mag-audio.com
WASP Line Array User Manual rev 1.00
5.5. Connecting a flying frame on the top
of a Sub H12
Required accessories:
WSF-01 (part No. 108017000) - 1 pcs
VA-0010 (part No. 0209000001) - 4 pcs
- Place the WSF-01 flying frame on the top
of a Sub H12, align so front and rear links of
a Sub H12 fit into receptacles of the frame
(Pic 1).
- Insert four VA-0010 8 mm pins into front
and rear links of the Sub H12.
5.6. Connecting a flying frame on the
bottom of a Sub H12
Required accessories:
WSF-01 (part No. 108017000) - 1 pcs
VA-0010 (part No. 0209000001) - 4 pcs
- Place the WSF-01 flying frame on the
bottom of a Sub H12, align so front and
rear links of a Sub H12 fit into receptacles
of the frame (Pic 1).
- Insert four VA-0010 8 mm pins into front
and rear links of the Sub H12.
5.4. Connecting a flying frame on the
bottom of a WASP module
Required accessories:
WSF-01 (part No. 108017000) - 1 pcs
VA-0010 (part No. 0209000001) - 2 pcs
VA-0018 (part No. 0209000021) - 1 pcs
- Release rear VA-0018 10 mm pin and
drop rear link down on WASP cabinet
(Pic 1).
- Place the WASP cabinet on the top of
the WSF-01 frame, align so front and rear
links of a cabinet fit into receptacles of the
frame (Pic 2).
- Insert two VA-0010 8 mm pins into
left and right front links of the cabinet,
choose required splay angle using rear link,
and insert one VA-0018 10 mm pin into
corresponding slot of the rear link. (Pic 3).
1
1
2
2
1
2
3
