Page 6 of 10
Assembly Instructions
Step 1:
● Remove tent from oversize carry bag, and then
remove the tie strap from around the tent.
● Insert one end of two Green Coded roof pole into
the holes (Green Coded) of plastic mold A1 on
Beam Pole1. Make sure the metal spring of the
roof pole lock into the plastic.
(Fig.1)
● Insert one end of another two Green Coded roof
poles into the holes(Green Coded) of plastic mold
A2 on Beam Pole 1. Make sure the metal spring
of roof pole lock into the plastic.
● Insert one end of the remain four Green Coded
roof poles into the holes(Green Coded) of plastic
mold B on Beam Pole 1.
(Fig.2)
● Hang the S-shaped iron hook on top of the
plastic.
(Fig.3) (Fig.4)
FIGURE 1
FIGURE 3
FIGURE 4
FIGURE 2
•
Assemble your tent before camping to become familiar with the assembly.
•
While setup is possible for one person, two people are recommended.
• Select a clean level campsite that is free of debris and sharp objects, away from natural watercourse.
• Ground cloth is recommended to prolong the life of the tent floor and provide additional insulation
and moisture protection.
•
Unzip tent doors and windows prior to disassembly to allow air circulation and prevent zipper damage
• Seam sealing is recommended for inner stitching of the tent to improve weather resistance. Beware
that when applying seam sealing to the outer stitching of the tent, discoloration may occur.
IMPORTANT NOTES BEFORE YOU BEGIN:
B
B
A2
A1
