Step 4:
● Unfold fly and stretch out all corners. Place the
fly over the tent. Use velcro tapes underneath
fly to wrap up the other end of short eave pole.
(Fig. 15).
● Attach the fly to the tent by attaching the "S"
hooks sewn on the fly to the D-rings on the steel
leg pole.
(Fig.16)
17
18
FIGURE 16
FIGURE 15
FIGURE 18
FIGURE 17
Step 5:
● Stake the tent to the ground by inserting steel
stakes through the rings and webbing loops
around then tent floor. Hammer stakes into the
ground at a 45° angle using a hammer or mallet.
Making sure to pull tent floor out evenly and
snugly.
(Fig. 17).
● Extend each of the guylines which are attached
to the fly. Make a loop at the opposite end of the
guylines by using slider as shown and place
loop over a tent stake. Tighten the guylines by
adjusting the slider
(Fig. 18).
NOTE:
Locate your tent to its final position
before securing it with stakes and
guylines.
Page 8 of 10
Assembly Instructions
