Setting User Options
43
Tone Options
The Magellan CrossoverGPS uses an alert tone to indicate that a maneuver is upcoming or
been completed. You can select the type of alert tone to be used.
Tone Options:
Tap on Bell, Chime or Beep.
Navigation Instruction (Vehicle Navigation only)
You can select what will be announced while routing. You may turn ‘Announce street
name” on (checked) or off and you may turn “Announce exit ramp name” on (checked) or
off.
GPS Options
You can check the status of the GPS signals or set a starting location for the GPS receiver.
GPS Status:
Displays high-level information about the satellite and the signal it is
transmitting.
Set GPS Position
: This is only useful if you have travelled a great distance with the
Magellan CrossoverGPS off and it is having problems getting GPS signals. You will
be prompted to enter an address for your present location that the Magellan
CrossoverGPS can base its satellite search from. (It is extremely unlikely that you
will ever need to use this option unless instructed to do so by a service technician
if you are experiencing difficulties.)
Backup and Restore (Vehicle Navigation only)
Backup and Restore will save (backup) all of your address, trips, and option settings to an
SD card installed in the Magellan CrossoverGPS. You can then upload (restore) this
information in the future should you lose the information or accidentally clear the
addresses.
Export Data / Import Data (Marine and Outdoor Navigation only)
Export and Import Data brings up a menu that enables you to save or load waypoints, trips
or tracks to an optional SD card. You can also backup and restore all of you data to an
optional SD card.
