Step 2
Page 2 of 4
© 2012
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
RE-2011
Part Number
13
14
15
16
17a/17b
18a/18b
19
20
21
Qty
1
1
1
1
1/1
1/1
1
1
1
Description
48.5”h Lower Curved Extrusion
48.5”h Upper Curved Extrusion
48.5”h Lower Curved Extrusion
48.5”h Upper Curved Extrusion
44”w Lower Horizontal Extrusion
44”w Upper Horizontal Extrusion
23”w Lower Horizontal Extrusion
23”w Upper Horizontal Extrusion
Backwall Support Leg Extrusion
Steps
1) Connect upper and lower vertical extrusions together [13 to 14 and 15 to 16].
2) Connect horizontal extrusions together [17a to 17b and 18a to 18b].
3) Attach horizontal assemblies [17a/17b and 18a/18b] between vertical
assemblies [5/6 and 13/14].
4) Attach horizontal extrusions [19 and 20] between vertical assemblies
[13/14 and 15/16].
5) Attach support leg extrusions [21] to back of verticals [15], see
leg attachment detail.
GREEN STAR
indicates location
of
connection lock with knob
.
Knob
**
Do not over tighten Knobs.
**
RED STAR
indicates location
of
connection bar
knob
.
Turn Knob Clockwise
to Tighten Lock
Rear View of Display
**
Do not over tighten Knobs.
**
Knob
Knob
Connection
Bar
5
6
13
14
15
16
17a
18a
19
20
12
17b
18b
A
A
A
B
B
21
Note:
Slide connection
bar between extrusions and
tighten knobs to secure.
Velcro at top of bar
Velcro at
top of bar
Velcro at bottom of bar
Velcro at left
& right of bar
Velcro at
right of bar
Graphic Attachment
Apply graphic to back
of assembled backwall.
BACK
VIEW
BACK VIEW
Light Connection
Attach lights to
backwall where
desired and
tighten in place.
Keep assembled
when shipping
Backside of backwall
Connect support leg to vertical
by placing lock into slot and
tighten with Allen Wrench.
Support Leg Attachment
(If accidentally removed from vertical)
Velcro at
bottom of bar
Backwall Assembly (Cont’d)
