Magene T100, Quick Start Manual

Connection to T100 Power Trainer

6

hand to open and close the quick release lever.Continue tightening the nut until  
you can feel the resistance from the lever when it reaches a position parallel to 
the hub. 
5. Hold the bike frame with your hand and push the quick release lever with your
palm until it is fully tightened, at which point the word "CLOSE"on the lever should
face outward and the level should be in front of or parallel to the fork legs. 
6. Note! If the Quick Release lever is not correctly tightened,it may cause property
loss or personal injury.If it is hard to attain proper tightness,please consult your local 
bicycle store or contact MAGENE.Please do not adjust the Quick Release lever while
cycling.

The LED indicator flashes slowly when installing a battery or turning pulley on this
product, at which point you can connect the product to your device via wireless
ANT + Bluetooth. When the connection is established, the LED will stop flashing
and remain turned on, indicating that the operation is successful.

T100 Power Trainer supports Zwift and other third-party software

.

An ANT receiver (sold separately) is required to connect the T100 Power Trainer
with a PC.

Smart power trainer may not be listed as an option in some third-party training
software or code table, in which case you can try to search by the keyword 
"power meter".