Warnings
!
8
7.2 Battery Installation
NOTE!
Before using, you should install two triple-A
batteries by following the procedures below
:
If the battery is exhausted, you need to replace it by following the procedured above.
1. Use the cross screwdriver to release the
screw fixing the control module in the arrow
direction shown.
2. Remove the control module and Install
two triple-A batteries.
3. Reset the control module,then tighten the
fixing bolt to complete battery replacement.
Battery Installation
Fig 8
Used dry batteries should be discarded immediately.
Keep children and pets away from the T100 Power Trainer during use.
Place T100 Power Trainer on a flat, stable surface before using it and consult your
doctor before starting and changing any workout plan.
Do not touch any moving part of the T100 Power Trainer with your hands or objects.
Beware that the rear flywheel will become very hot after using the T100 Power
Trainer for a long time, make sure not to touch it.
Never try to disassemble the batteries.
If the product will not be used for a long time,remove the batteries to avoid
battery leakage which may cause damage to the product.
Summary of Contents for T100
Page 1: ...T100 Power Trainer Quick start Guide...
Page 11: ......