9
(D)
(E)
(F)
6.0 mm
(C)
Setscrew (B)
(A)
MECHANICAL ADJUSTMENT
PRESSER BAR HEIGHT AND ALIGNMENT
TO CHECK:
1. Raise the presser foot lifter (A).
2. The distance between the presser foot (D) and the needle plate (E) should be 6.0 mm.
ADJUSTMENT PROCEDURE:
1. Remove the face cover (see page 4). Remove the setscrews (B) and the face plate set plate.
2. Raise the presser foot lever and loosen the hexagonal socket screw (C) on the presser bar holder.
Adjust the distance between the presser foot (D) and the needle plate (E) to 6.0 mm.
3. Tighten the hexagonal socket screw (C) securely.
4. Tighten the setscrew (B) to attach the face plate set plate.
5. Attach the face cover.
NOTE:
When you tighten the setscrew (B), make sure that both sides of the presser foot
are parallel to the feed dog slot (F) on the needle plate.
Face plate
set plate
Summary of Contents for 43
