ADJUSTING THE MAGENTA TT10 TURNTABLE
This template gives a general and useful indication. However, there are arms that were designed with a completely different geometry. I
recently acquired the SAEC WE 308 arm and the makers strived for the least error at the end of the record where the most distortion can
occur because in a shorter groove length the same info has to be engraved as in the outer groove.
Add to this that most of the time very loud passages are engraved, and you will understand that optimal tracking has to be near the end of
the record. But only then if the angle is not too much elevated on other spots.
The template below can tell you what the measure of lateral tracking angle in degrees is. Does not matter at what point you do measure. You
can choose the least error at whatever distance from the spindle.