http://www.magewell.com
8 / 12
Copyright © 2008-2011 南京美乐威电子科技有限公司，保留所有权利
7.3.1. Input Signal
7.3.1.1. Input Interface
Supporting only DVI signal, all automatic selection input interface is gray
1.1.1.2 Signal State
The relevant parameters of signal are shown, such as total number of rows, frame rate (p is
progressive scan, i is interlaced), mode, audio frequency.
1.1.1 Image Adjustment
By default, image is auto, but auto cannot achieve desired effect, such as black border, unclear
image, picture which needs clipping, it must be adjusted manually. After adjustment, you can save
the preset. Then you can apply preset values without adjustment when the same signal accesses.
Black border adjustment
: Through adjust left margin and top margin to eliminate black
border. Every time you can adjust 1 pixel.
Image clipping
: Through adjust image width, height, left margin and top margin to achieve
desired requirement. Increasing/reducing width of image starts from right, increasing/reducing
height of image starts from below.
Skills of image clipping as follows:
1. Set scale full output image to confirm whether clipping adjustment is appropriate.
2. Cut off left margin of image: firstly increase left margin, then reduce image width.
3. Cut off right margin of image: reduce image width.
4. Cut off top margin of image: firstly reduce image height, and then increase top margin.
5. Cut off lower margin of image: reduce image height.
After image adjustment completes, click "
Save Preset
" to save current adjustment; click "
Del
preset
" to delete preset you saved; click "
Apply Preset
" to apply the saved preset to current
settings.
